Configuring the MSDP originator ID

Configure the originator ID to set the RP address inside the SA message. The RP address must be a pre-configured CLIP interface on the global router or a VRF. The RP address is also the local IP address in all peer relations.

Note

Originator ID cannot be deleted if MSDP is enabled.

Procedure

In the navigation pane, expand Configuration > IP.
Click MSDP.
Click the Globals tab.
In the RPAddress box, type the IP address to use as the originator ID.
Click Apply.

Global field descriptions

Use the data in the following table to use the Globals tab.


Name	Description
Enabled	Enables MSDP. If you clear this check box, you disable MSDP. The default setting is clear (disabled).
CacheLifetime	Configures the lifetime given to SA cache entries when created or refreshed.
NumSACacheEntries	Displays the total number of entries in the SA cache.
RPAddress	Specifies the IP address to use as the originator ID. If the address is not a system local address, the system rejects the configuration.
RouteMapName	Specifies the name of the optional route policy to create or modify. You do not need to create a route policy to use the redistribution filter. Note: To delete the route map name, clear the field and click Apply.
RedistributeFilterEnabled	Filters the (S,G,RP) entries provided by PIM to MSDP. The default is clear (disabled).
RedistruteFilterApply	Applies the changes made to the redistribute filter.
StatsClear	Clears MSDP statistics.