Configure Remote SPBM Parameters

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure remote SPBM global parameters. SPBM uses the remote Intermediate-System-to-Intermediate-System (IS-IS) link state routing protocol to provide a loop free Ethernet topology that creates a shortest path topology from every node to every other node in the network based on node MAC addresses.

Procedure

In the navigation pane, expand the Configuration > IS-IS folders.
Select SPBM Remote.
Select the SPBM tab.
Select Insert to create a remote SPBM instance.
Configure the remote SPBM parameters.
Select Insert.

SPBM Field Descriptions

Use data in the following table to use the SPBM tab.


Name	Description
Id	Specifies the remote SPBM instance ID.
NodeNickName	Specifies a nickname for the remote SPBM instance globally. The value is 2.5 bytes in the format <x.xx.xx>.
PrimaryVlan	Specifies the primary SPBM B-VLANs to add to the remote SPBM instance.
Vlans	Specifies the SPBM B-VLANs to add to the remote SPBM instance.
LsdbTrap	Enables or disables a trap when the SPBM LSDB changes. The default is disable.
IpShortcut	Enables or disables SPBM IP shortcut state. The default is disable.
SmltSplitBEB	Specifies whether the switch is the primary or secondary vIST peer. The default is primary.
SmltVirtualBmac	Specifies a virtual MAC address that can be used by both peers.
SmltPeerSysId	Specifies the system ID of the SPBM SMLT for this remote SPBM instance.
Mcast	Specifies if IP multicast over remote SPBM is enabled. The default is disabled.
McastFwdCacheTimeout	Specifies the global forward cache timeout in seconds. The default is 210 seconds.
Ipv6Shortcut	Enables or disables SPBM IPv6 shortcut state. The default is disable.
McastSpbPimGwControllerEnable	Enables or disables ISIS PLSB Multicast SPB PIM Gateway controller. Disabled by default.
McastSpbPimGwGatewayEnable	Enables or disables ISIS PLSB Multicast SPB PIM Gateway. Disabled by default.
StpMultiHoming	Enables or disables MSTP-Fabric Connect Multi Homing. The default is disabled (false).
BVlanOrigin	Specifies the origin of the B-VLAN. The values are: config - manual configuration using CLI or SNMP. dynamic - through Zero Touch Fabric Configuration and Auto-sense. The default is dynamic.