Configuring PoE Power Usage Threshold

About this task

Perform the following procedure to configure the PoE power usage threshold limit globally as a percentage on the switch. The switch logs a warning message when a PoE PD power usage exceeds the configured threshold. The switch logs an informational message when a PoE PD power usage is below the configured threshold.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Configure the power usage threshold:

    poe poe-power-usage-threshold <1–99>.

Variable Definitions

The following table defines parameters for the poe-power-usage-threshold command.

Variable

Value

<1–99>

Specifies the PoE usage threshold in the range of 1—99 percent.