Configure Route Advertisement on the Management Port

Configure route advertisement in IPv6 on the management port for neighbor discovery (ND).

Note

This procedure supports Layer 2 or Layer 3 route advertisement on VSP 8600 Series only.

1. Enter mgmtEthernet Interface Configuration mode:

   enable

   configure terminal

   interface mgmtEthernet <mgmt | mgmt2>

2. Configure the number of neighbor solicitation messages from duplicate address detection:

   ipv6 nd dad-ns <0–600>

3. Configure the hop limit sent in router advertisements:

   ipv6 nd hop-limit <0–255>

Example

Switch:1(config-if)#ipv6 nd dad-ns 2
Switch:1(config-if)#ipv6 nd hop-limit 2

Switch:1(config-if)#show ipv6 nd interface mgmtethernet mgmt

======================================================================================================
                                             Mgmt Ipv6 Nd
======================================================================================================
IFID MGMT-IF RTR-ADV MAX-INT MIN-INT LIFETIME MANAG OTHER DAD-NS MTU     HOP    REACHABLE RETRANSMIT
                                             FLAG  CONF                 LIMIT  TIME      TIME
------------------------------------------------------------------------------------------------------
64   mgmt   False   600     200     0        False False 2      0(d)    2(s)   0(d)      0(d)

Note:  (s) = Set, (d) = Default, (i) = inherit.

1 out of 5 Total Num of Ipv6 ND Entries displayed.