The following table defines parameters for the convert command.
| Variable | Value |
|---|---|
|
<A.B.C.D A.B.C.D | A.B.C.D/X> |
Specifies the IP address and subnet mask. This parameter applies to the following Management Instance interface types:
|
|
<A.B.C.D> |
Specifies the gateway IP address. This parameter applies to the following Management Instance interface types:
|
|
<1-16777215> |
Specifies the service instance identifier (I-SID). This parameter applies to the Management Instance VLAN
interface type.
Note: You can specify the I-SID for a switch not
configured as a DvR Leaf node.
|
|
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} |
Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port. |
|
<0-3600> |
Specifies the time in seconds between when the command is issued and when the command changes automatically roll back to the previous configuration. The default is 120 seconds. To disable the rollback, enter 0. |
|
<2-4059> |
Specifies the VLAN ID in the range of 2 to 4059. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. By default, the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. This parameter applies to the Management Instance VLAN interface type only. |
|
WORD<0-16> |
Specifies the vrf name. This parameter applies to the Management Instance CLIP interface type only. |