Configure a Segmented Management Instance Interface as Default Topology IP

Note

This procedure does not apply to VSP 8600 Series.

Use this task to configure a Management Instance with a default topology IP.

Note

You can only configure one Management Instance interface as the default topology IP.

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Enter the configuration mode for the Management Instance:

   mgmt {clip | oob | vlan}

3. Configure the Management Instance as the default topology IP.

   force-topology-ip

Example

The following example configures the Segmented Management Instance VLAN as the default topology IP:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#mgmt vlan
Switch:1(mgmt:vlan)#force-topology-ip