Configure an IPv4 IS-IS Accept Policy for a Specific Advertising BEB and I-SID-list

Configure an IS-IS accept policy to apply to a specific advertising Backbone Edge Bridge (BEB) for a specific I-SID list to represent local or remote Layer 3 VSNs, which allows the system to redistribute the remote VSNs to the VSN where you applied the filter.

Note

Note

If the route policy changes, you must reapply the IS-IS accept policy, unless it was the last sequence in the configuration.

Before you begin

  • Enable IS-IS globally.

  • Ensure the manual area exists.

  • You must configure a route-map to apply.

About this task

The system uses the default global filter unless a filter for a specific advertising BEB exists, in which case the system applies a more specific filter.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Click IS-IS.
  3. Click the Accept Nick-Name Isid-List tab.
  4. Click Insert.
  5. In the AdvertisingRtr field, specify the SPBM nickname.
  6. In the Name field, specify an I-SID list name.
  7. Select enable in the Enable check box to enable the filter.
  8. In the PolicyName field, specify the route-map name.
  9. Click Insert.

Accept Nick–Name Isid-List field descriptions

Use the data in the following table to configure the Accept Nick-Name Isid-List tab.

Name

Description

AdvertisingRtr

Specifies the SPBM nickname to allow you to apply the IS-IS accept policy to routes for a specific advertising BEB. The system first uses the default filter, but if a more specific filter is present the device applies the specific filter.

The value is 2.5 bytes in the format <x.xx.xx>.

Name

Specifies the name of the I-SID list used to filter.

Enable

Enables or disables the SPBM nickanme advertising router entry. You must enable the value to filter. The default is disabled.

PolicyName

Specifies a route policy name.

BackBonePolicyName

Specifies a backbone route policy name.