Viewing MLT port members

1. Enter Global Configuration mode:

   enable

   configure terminal

2. View information about the specified MLT:

   show mlt [<1-512>]

Example

Note

The show mlt [<1-512>] command displays remote port members only if the MLTs are configured on vIST peers that use the same MLT ID.

If the MLT is between two devices that use the same MLT ID, but they are not vIST peers, show mlt [<1-512>] does not display the remote port members in the output.

In this first example, MLT 512 is an MLT between two vIST peers with the same ID used on both peers. In this case, the output displays the remote port members.

Switch:1(config)# show mlt 512

==========================================================================================
                                    Mlt Info

==========================================================================================
                        PORT    MLT   MLT        PORT         VLAN
MLTID IFINDEX NAME      TYPE   ADMIN CURRENT    MEMBERS       IDS
------------------------------------------------------------------------------------------
512    6655   MLT-512    trunk  norm   norm     1/24         1000 2000

               DESIGNATED   LACP      LACP
MLTID IFINDEX  PORTS        ADMIN     OPER
------------------------------------------------------------------------------------------
512    6655    null          disable   down

                                                               WHICH PORTS
                WHERE      LOCAL             REMOTE            PROGRAMMED
MLTID NAME      CREATED    PORT MEMBERS      PORT MEMBERS      IN DATA PATH
------------------------------------------------------------------------------------------
512   MLT-512   LOCAL        1/24              3/24              LOCAL

               ENCAP                          
MLTID IFINDEX  DOT1Q     LOSSLESS   
------------------------------------------------------------------------------------------
512   6655     enable     disable    

In this second example, MLT 1 is an MLT between two devices that are not vIST peers so the output does not display the remote port members.

Switch:1(config)# show mlt 1

==========================================================================================
                                    Mlt Info

==========================================================================================
                        PORT    MLT   MLT        PORT         VLAN
MLTID IFINDEX NAME      TYPE   ADMIN CURRENT    MEMBERS       IDS
------------------------------------------------------------------------------------------
1      6144   MLT-1    trunk   norm   norm     1/5          1000 2000

               DESIGNATED   LACP      LACP
MLTID IFINDEX  PORTS        ADMIN     OPER
------------------------------------------------------------------------------------------
1    6144      1/5          disable   down

                                                               WHICH PORTS
                WHERE      LOCAL             REMOTE            PROGRAMMED
MLTID NAME      CREATED    PORT MEMBERS      PORT MEMBERS      IN DATA PATH
------------------------------------------------------------------------------------------
1     MLT-1     LOCAL       1/5                                LOCAL

               ENCAP                          
MLTID IFINDEX  DOT1Q     LOSSLESS   
------------------------------------------------------------------------------------------
1   6144     enable     disable