Displaying LACP Statistics for Specific Ports

Display individual LACP statistics for specific ports to manage network performance.

Note

Note

Slot and port information can differ depending on hardware platform.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. View statistics for specific ports:

    show interfaces GigabitEthernet statistics lacp [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Example

View LACP statistics:

Switch:1>enable
Switch:1#show interfaces gigabitethernet statistics lacp

================================================================================
                                Port Stats Lacp
================================================================================
PORT TX     RX     TX        RX        TX            RX            RX      RX
NUM  LACPDU LACPDU MARKERPDU MARKERPDU MARKERRESPPDU MARKERRESPPDU UNKNOWN ILLEGAL
--------------------------------------------------------------------------------
1/39  0        0        0          0          0               0    0       0
1/40  0        0        0          0          0               0    0       0
2/37  0        0        0          0          0               0    0       0
2/38  0        0        0          0          0               0    0       0

Variable Definitions

Use the data in the following table to use the show interfaces GigabitEthernet statistics lacp command.

Variable

Value

{slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
9037147-00 Rev AB