Configuring an IPv6 RIPng interface

Configure RIPng parameters on an interface so you can control RIPng behavior on the interface.

About this task

RIPng does not operate on an interface until you enable it globally and on the interface.

You can also configure an IPv6 RIPng interface for a brouter port by selecting Device Physical View , selecting a port, and following the Edit > Port > IPv6 navigation path. You can configure an IPv6 RIPng interface for a VLAN through the VLAN > VLANs > Basic > IPv6 navigation path. This procedure uses the main IPv6 RIPng navigation path where you can create both types of interfaces.

Before you begin

  • Configure a routing interface (either a brouter port or a virtual routing interface).

  • Assign an IP address to the interface.

  • Enable RIPng globally.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > IPv6.
  2. Click IPv6 RIPng.
  3. Click the Interfaces tab.
  4. Click Insert.
  5. In the IfIndex box, type a value to identify the IPv6 interface.
  6. In the RipAdminStatus option box, select enable.
  7. Configure other parameters as required.
  8. Click Insert.

Interfaces field descriptions

Use the data in the following table to use the Interfaces tab.

Name

Description

IfIndex

RIPng interface index.

RipAdminStatus

Enable or disable RIPng on an interface.

DefaultInfoState

Enable or disable default information at the interface level.

Cost

Specifies the RIPng metric cost.

Poison

Enable or disable poison reverse on an RIPng interface.

RipOperStatus

Enable or disable the RIPng operational state on an interface.