Configure Auto-sense Access Ports

Note

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

About this task

Perform this procedure to configure ports operating in Auto-sense mode to determine the Layer 3 Quality of Service (QoS) actions the switch performs. The Auto-sense access ports override the Differentiated Services Code Point (DSCP) markings.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Configure Auto-sense access ports:

    auto-sense access-diffserv [enable]

Example

Configure the Auto-sense access ports:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#auto-sense access-diffserv enable

Variable Definitions

The following table defines parameters for the auto-sense access-diffserv command.

Variable Value
enable

Configures the ports operating in Auto-sense mode to determine the Layer 3 Quality of Service (QoS) actions the switch performs. The Auto-sense access ports override the Differentiated Services Code Point (DSCP) markings. The default configuration is enabled.