View uPnP Filtering information on an IGMP-enabled interface

Use the following command to display uPnP Filtering information on an IGMP-enabled interface.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Display information about the interfaces where IGMP is enabled:

    show ip igmp interface [gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}][vlan <1-4059>[vrf WORD<1–16>][vrfids WORD<0–512>]

Example

View the default uPnP Filtering information on an IGMP-enabled interface:

Switch:1#show ip igmp interface vlan 2
========================================================================================
                                  Vlan Ip Igmp
========================================================================================
VLAN QUERY QUERY ROBUST VERSION LAST  PROXY  SNOOP  SNOOP    SSM    UPnP   FAST   FAST
ID   INTVL MAX                  MEMB  SNOOP  ENABLE ORIGIN   SNOOP  FILTER LEAVE  LEAVE
           RESP                 QUERY ENABLE                 ENABLE ENABLE ENABLE PORTS
----------------------------------------------------------------------------------------
2   125   100   2      2       10    false   false   RADIUS   false   false   false        

VLAN SNOOP   SNOOP           DYNAMIC   COMPATIBILITY EXPLICIT UPnP  
ID   QUERIER QUERIER         DOWNGRADE MODE          HOSTS    FILTER
     ENABLE  ADDRESS         VERSION                 TRACKING ADDRESS
----------------------------------------------------------------------------------------
2   false   0.0.0.0         enable    disable       disable  239.255.255.250/32

View uPnP Filtering information on an IGMP-enabled interface when uPnP Filtering is enabled and a non-default multicast group address is configured:

Switch:1(config)#show ip igmp interface vlan 2
=======================================================================================
                                  Vlan Ip Igmp
=======================================================================================
VLAN QUERY QUERY ROBUST VERSION LAST  PROXY  SNOOP  SNOOP    SSM    UPnP   FAST   FAST
ID   INTVL MAX                  MEMB  SNOOP  ENABLE ORIGIN  SNOOP  FILTER LEAVE  LEAVE
           RESP                 QUERY ENABLE                ENABLE ENABLE ENABLE PORTS
---------------------------------------------------------------------------------------
2    125   100   2      2       10    false  false  RADIUS   false  true   false

VLAN SNOOP   SNOOP           DYNAMIC   COMPATIBILITY EXPLICIT UPnP
ID   QUERIER QUERIER         DOWNGRADE MODE          HOSTS    FILTER
     ENABLE  ADDRESS         VERSION                 TRACKING ADDRESS
---------------------------------------------------------------------------------------
2    false   0.0.0.0         enable    disable       disable  233.252.0.0/24

Variable Definitions

The following table defines parameters for the show ip igmp interface command.

Variable

Value

gigabitethernet {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

vlan <1-4059>

Specifies the VLAN.

vrf WORD<1–16>

Specifies the VRF by name.

vrfids WORD<0–512>

Specifies the VRF by VRF ID.