Configure Logical Interface Tunnel on Fabric IPsec Gateway VM

About this task

Perform this procedure to configure a Fabric Extend (FE) tunnel with only fragmentation and reassembly capabilities, on the Fabric IPsec Gateway Virtual Machine (VM).

Procedure

Enter Fabric IPsec Gateway Configuration mode:

enable

virtual-service WORD<1-128> console

Note

Type CTRL+Y to exit the console.
Configure the logical interface destination IP address for the specific tunnel:

set logical-intf-tunnel <1-255> fe-tunnel-dest-ip {A.B.C.D}
Configure the Maximum Transmission Unit (MTU) value for the specific tunnel:

set logical-intf-tunnel <1-255> mtu <750-9000>

Note

The MTU range <750-9000> is applicable for FE tunnels with only fragmentation and reassembly capabilities.
Configure tunnel name:

set logical-intf-tunnel <1-255> tunnel-name WORD <1-64>
Configure the egress shaping rate for a specific tunnel:

set logical-intf-tunnel <1-255> egress-shaping-rate <1-1000>

Example

Configuring logical interface tunnel on Fabric IPsec Gateway VM:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> set logical-intf-tunnel 2 fe-tunnel-dest-ip 192.0.2.50
FIGW> set logical-intf-tunnel 2 mtu 1300
FIGW> set logical-intf-tunnel 2 egress-shaping-rate 5
FIGW> set logical-intf-tunnel 2 tunnel-name Tunnel-to-BEB2

Variable Definitions

The following table defines parameters for the set logical-intf-tunnel command.


Variable	Value
`<1-255>`	Specifies the unique ID for the logical interface tunnel.
fe-tunnel-dest-ip `{A.B.C.D}`	Specifies the FE tunnel destination IP address for the logical interface.
mtu `<750-9000>`	Specifies the Maximum Transmission Unit (MTU) value for the FE tunnel with only fragmentation and assembly capabilities.
tunnel-name `WORD <1-64>`	Specifies a name for the the logical interface tunnel.
egress-shaping-rate`<1-1000>`	Specifies the egress shaping rate for the logical interface tunnel.