Configuring an ACE IPv6 destination address

Configure ACE IPv6 destination address entries to have the filter look for specific destination IP addresses.

Before you begin

  • The ACL exists.

  • The ACE exists.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > Security > Data Path.
  2. Click Advanced Filters (ACE/ACLs).
  3. Click the ACL tab.
  4. Select the appropriate ACL.
  5. Click ACE.
  6. Select the appropriate ACE.
  7. Click IPv6.
  8. Click the Destination Address tab.
  9. Click Insert.
  10. In the Oper field, select the operation type.
  11. In the List field, enter the destination IP address.
  12. In the OperMask field, enter the operation mask value.
  13. Click Insert.

Destination Address field descriptions

Use the data in the following table to use the Destination Address tab.

Name

Description

AclId

Specifies the ACL ID.

AceId

Specifies the ACE ID.

Oper

The eq and mask parameters specify an operator for a field match condition: equal to or mask. The mask operator is an implied eq on the mask bits.

List

Specifies the destination IP address.

OperMask

Specifies the mask value for the destination IP address.
9037147-00 Rev AB