Configure Remote IS-IS Manual Area

Note

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure the remote Intermediate System-to-Intermediate System (IS-IS) manual area.

Procedure

  1. Enter IS-IS Router Remote Configuration mode:

    enable

    configure terminal

    router isis remote

  2. Configure the manual-area:

    manual-area xx.xxxx.xxxx...xxxx

Example

Configuring remote IS-IS manual area:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis remote
Switch:1(config-isis-remote)manual-area c1.1000.000.00

What to do next

To verify the configuration, see Display IS-IS Remote Area Configuration and Display IS-IS Area Configuration.

Variable Definitions

The following table defines parameters for the manual-area command.

Variable Value
<xx.xxxx.xxxx...xxxx>

Specifies the remote IS-IS manual-area in the range of 1 to 13 bytes.
9037147-00 Rev AB