Configuring route redistribution to RIPng

Configure a redistribute entry to announce routes of a certain source protocol type into the RIPng domain, for example, static, RIP, or direct. Use a route policy to control the redistribution of routes.

Before you begin

  • Enable RIP globally.

  • Configure a route policy.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > IPv6.
  2. Click IPv6 RIPng.
  3. Click the Redistribute tab.
  4. Double-click the value in the Enable column that corresponds with the source protocol type you want to enable or disable.
  5. Select enable or disable from the list.
  6. Click Apply.

Redistribute field descriptions

Use the data in the following table to use the Redistribute tab.

Name

Description

DstVrfiId

Specifies the destination VRF ID used in the redistribution.

Protocol

Specifies the dynamic routing protocol that receives the external routing information.

SrcVrfId

Specifies the source VRF ID used in the redistribution.

RouteSource

Specifies the route source protocol for the redistribution entry.

Enable

Enables (or disables) a RIPng redistribute entry for a specified source type.