Enable Dot3 LLDP TLVs

About this task

Use this procedure to enable transmission of dot3 MAC/PHY configuration/status Link Layer Discovery Protocol (LLDP) TLV.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Enable LLDP TLVs for transmission on a specific port:
    lldp tx-tlv dot3 {mac-phy-config-status}
  3. Verify the configuration:
    show lldp tx-tlv dot 3

Example

Enable LLDP TLVs for transmission on a specific port:

Switch:1>enable
Switch:1#config
Configuring from terminal or network [terminal]? t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#interface gigabitethernet 1/2
Switch:1(config-if)#lldp tx-tlv dot3 mac-phy-config-status
Switch:1(config-if)#show lldp tx-tlv dot3
=======================================================================
                              LLDP port dot3 tlvs
======================================================================= 
----------------------------------------------------------------------- 
Port       MAC Physical
           Config Status
-----------------------------------------------------------------------
1/1        disabled
1/2        enabled
1/3        enabled
1/4        disabled
1/5        disabled

Variable Definitions

The following table defines parameters for the lldp tx-tlv dot3 command.

Variable

Value

mac-phy-config-status

Specifies the status of the MAC Physical Config Status TLV.

The default is disabled.