Configure Remote SPBM Parameters on the Interface
Note
This procedure only applies to the VSP 7400 Series.
About this task
Perform this procedure to configure the remote SPBM interface parameters.
Procedure
- In the navigation pane, expand the folders.
- Select SPBM Remote.
- Select the Interfaces SPBM tab.
- Select Insert to create a remote SPBM instance on the interface.
- Configure the remote SPBM interface parameters.
- Select Insert.
Interfaces SPBM Field Descriptions
Use the data in the following table to use the Interfaces SPBM tab.
|
Name |
Description |
|---|---|
|
Index |
Specifies an Index value for the remote SPBM interface. |
|
SpbmId |
Specifies the remote SPBM ID. |
|
State |
Specifies whether the remote SPBM interface is enabled or disabled. |
|
Type |
Configures the remote SPBM instance interface-type on the IS-IS interface on the specific port or MLT, the values are point-to-point (ptpt) or broadcast (bcast). The system supports the ptpt interface type only. |
|
L1Metric |
Configures the remote SPBM instance l1-metric on the IS-IS interface on the specific port or MLT. The default value is 10. |
| Origin |
Specifies the source of the remote SPBM instance configuration.
|