Enabling SPB-PIM Gateway on a brouter port interface

Enable SPB-PIM Gateway on a brouter port.

Procedure

  1. Enter GigabitEthernet Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Enable SPB-PIM Gateway on a brouter port:
    ip spb-pim-gw enable
    Note

    Note

    SPB-PIM Gateway cannot be enabled under the following circumstances:

    • If the IP interface is not configured using the brouter command

    • If the IP interface does not exist on the brouter port

    • If the spbm_config_mode boot flag is set to false

    • If ip igmp snooping is enabled

    • If the spb-multicast is enabled on the brouter port

    • If the brouter port is part of an SMLT or vIST Vlan

    • If the brouter port has an i-sid configured

9037147-00 Rev AB