Disable Auto-sense DHCP Server Detection

Note

This procedure does not apply to VSP 8600 Series and XA1400 Series.

About this task

Perform this procedure to disable Dynamic Host configuration Protocol (DHCP) server detection in Auto-sense mode.

Note

By default Auto-sense DHCP server detection is enabled. This ensures automatic detection of the DHCP uplink ports in Zero Touch Deployment.

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Disable DHCP server detection:

   no auto-sense dhcp-detection

Example

Enable DHCP server detection:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#no auto-sense dhcp-detection