Configure the Auto-sense Wait Interval

About this task

Perform this task to configure the time, in seconds, for Auto-sense to wait for a Link Layer Discovery Protocol (LLDP) neighbor to be detected in the Auto-sense wait state before transitioning to the Auto-sense onboarding state.

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Configure the Auto-sense wait interval:

   auto-sense wait-interval <10-120>

3. Verify the Auto-sense wait interval information:

   show auto-sense wait-interval

Example

Configure the Auto-sense wait interval as 50 seconds:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#auto-sense wait-interval 50

Verify the Auto-sense wait-interval information:

Switch:1>show auto-sense wait-interval
============================================================================
                                 AUTO-SENSE GLOBAL Config
============================================================================
WAIT
INTERVAL
----------------------------------------------------------------------------
50
----------------------------------------------------------------------------

----------------------------------------------------------------------------
0 out of 0 Total Num of AUTO-SENSE entries displayed
----------------------------------------------------------------------------