Clearing NEAP session

Use this procedure to clear the NEAP session that is learnt on the switch.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Clear the NEAP session:

    clear eapol non-eap [<0x00:0x00:0x00:0x00:0x00:0x00>] [{slot/port[/sub-port][-slot/port[/sub-port]][,...]} <0x00:0x00:0x00:0x00:0x00:0x00>]

Example

Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# clear 1/16 00:1b:63:84:45:e6

Variable Definitions

The following table defines parameters for the clear eapol non-eap command.

Variable

Value

{slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Specifies the port list on which the NEAP MAC is learnt.

0x00:0x00:0x00:0x00:0x00:0x00

Specifies the MAC-Address on the NEAP session.