Configure Remote IS-IS Hello Multiplier on a Port

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure the remote hello multiplier to specify how many hellos the switch must miss before it considers the adjacency with a neighboring switch down.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the level 1 hello multiplier:

isis remote l1-hello-multiplier <1-600>

Example

Configuring the remote hello multiplier on port 1/2:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/2
Switch:1(config-if)#isis remote l1-hello-multiplier 1

Variable Definitions

The following table defines parameters for the isis remote l1-hello-multiplier command.


Variable	Value
`<1-600>`	Configures the Level 1 hello multiplier. The default value is 3 seconds.