Configure Remote IS-IS Multi-area SPB Nickname for an SPBM Instance

Note

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure remote IS-IS Multi-area SPB nickname for a specific SPBM instance on the switch.

Procedure

  1. Enter IS-IS Router Remote Configuration mode:

    enable

    configure terminal

    router isis remote

  2. Configure IS-IS Multi-area SPB nickname:

    spbm <1-100> nick-name <x.xx.xx>

Example

Configuring remote IS-IS Multi-area SPB nickname for SPBM instance:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis remote
Switch:1(config-remote)spbm 4 nick-name 1.11.16

What to do next

To verify the configuration, see Display the Remote IS-IS SPBM Nickname Configuration.

Variable Definitions

The following table defines parameters for the spbm command.

Variable Value
<1-100>

Specifies the SPBM instance on the remote IS-IS interface.
nick-name<x.xx.xx>

Specifies a nickname for the remote IS-IS SPBM Multi-area SPB instance. The value is 2.5 bytes in the format <x.xx.xx>.
9037147-00 Rev AB