Display MLD Interface Information

About this task

Use this procedure to display MLD snooping interface parameters.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Display MLD interface information:

    show ipv6 mld interface [gigabitethernet {slot/port[/sub-port]}] [vlan <1-4059>]

Examples

Switch:1#show ipv6 mld interface
==========================================================================================
                         Mld Interface - GlobalRouter
==========================================================================================
IF   STATUS VERS  OPER VERS QUERIER                                 Wrong Query JOINS MODE
------------------------------------------------------------------------------------------
P6/3 inact  2     2         2001:0db8:3c4d:0015:0000:0000:1a2f:1aaa   0      		0     pim
V666 inact  2     2         2001:0db8:3c4d:0015:0000:0000:1a2f:1bbb   0 	     	0     pim

Switch:1#show ipv6 mld interface vlan 10
================================================================================
                                  Vlan IPv6 Mld
================================================================================
VLAN QUERY QUERY ROBUST VERSION LAST  SNOOP  SSM     DYNAMIC
ID   INTVL MAX                  LIST  ENABLE SNOOP   DOWNGRADE
           RESP                 QUERY        ENABLE 
--------------------------------------------------------------------------------
10   125   10    2      1       1     false  false   enabled

Switch(config)#show ipv6 mld interface gigabitethernet 1/11
================================================================================
                                 Port IPv6 MLD

================================================================================
PORT QUERY QUERY ROBUST VERSION LAST  DYNAMIC
NUM  INTVL MAX                  LIST  DOWNGRADE
           RESP                 QUERY
--------------------------------------------------------------------------------
1/11 125   10    2      1       1     enabled

1 out of 1 entries displayed

Variable Definitions

The following table describes the variables for the show ipv6 mld interface command.

Variable Value

vlan <1-4059>

Displays MLD snooping information for the configured VLANs.

gigabitEthernet {slot/port[/sub-port]}

Displays MLD snooping information on a specific interface.