Displaying RADIUS dynamic server information

About this task

Use the following procedure to display information about the configuration of RADIUS dynamic session changes.

Procedure

  1. To enter User EXEC mode, log on to the switch.
  2. Display information about dynamic change configuration:

    show radius dynamic-server [client | statistics]

Example

Switch:1#show radius dynamic-server

==========================================================================================
                        RADIUS Dynamic Authorization General Info
==========================================================================================
CLIENT                                   UDP        CLIENT     SECRET
ADDRESS                                  PORT       ENABLED    KEY
------------------------------------------------------------------------------------------
192.0.2.15                               1026       Disabled   ****************
192.0.2.16                               1027       Disabled   ****************
------------------------------------------------------------------------------------------

All 2 out of 2 Total Num of RADIUS Dynamic Authorization clients displayed

Display dynamic server statistics:

Switch:1#show radius dynamic-server statistics

================================================================================
                 RADIUS Dynamic Authorization Global Statistics
================================================================================
Disconnects From Invalid Client Addresses:     0
CoAs From Invalid Client Addresses:            0
--------------------------------------------------------------------------------

Variable Definitions

The following table defines parameters for the show radius dynamic-server command.

Variable

Value

client WORD<0-46>

Display RADIUS Dynamic Authorization configuration values for the specified client.

statistics

Display statistics for RADIUS Dynamic Authorization clients.