Verify the Software Release

About this task

Use CLI to verify your installed software. It is important to verify your software version before you place a device into a production environment.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. Verify the software release:

    show software detail

Example

The following is an example of the output of the show software detail command.

Switch:1#show software detail


================================================================================
                    software releases in /intflash/release/                     
================================================================================
VSPSwitch.X.X.X.X_GA                                                             
  MP                                                                            
    UBOOT                            int009
    KERNEL                           2.6.32_int29
    ROOTFS                           2.6.32_int29
    APPFS                            VSPSwitch.X.X.X.X_GA 
  AVAILABLE ENCRYPTION MODULES
    No Modules Added

VSPSwitch.X.X.X.X_GA  (Backup Release)
  MP
    UBOOT                            int009
    KERNEL                           2.6.32_int29
    ROOTFS                           2.6.32_int29
    APPFS                            VSPSwitch.X.X.X.X_GA 
  AVAILABLE ENCRYPTION MODULES
    No Modules Added

VSPSwitch.X.X.X.X_GA  (Primary Release)
  MP
    UBOOT                            int009
    KERNEL                           2.6.32_int29
    ROOTFS                           2.6.32_int29
    APPFS                            VSPSwitch.X.X.X.X_GA
  AVAILABLE ENCRYPTION MODULES
    No Modules Added


--------------------------------------------------------------------------------
Auto Commit     : enabled
Commit Timeout  : 10 minutes