Save Running Configuration to a File

About this task

Perform this procedure to save the current configuration on Fabric IPsec Gateway Virtual Machine (VM) to a specific file.

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Save configuration to the default configuration file:

    save config [-y]

  3. Save configuration to a specific file in the Fabric IPsec Gateway VM.

    save config file WORD <1-255> [-y]

Example

Save the Fabric IPsec Gateway configuration to file "test":

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW>save config file test.txt
File already exists, do you want to overwrite [y/n]: y

Save the Fabric IPsec Gateway configuration to file "test", forcing the switch to overwrite the file without confirmation:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> save config file test.txt -y

Variable Definitions

The following table defines parameters for the save config command.

Variable Value
file WORD <1-255> Specifies the name of file to save the configuration of the Fabric IPsec Gateway VM.

-y

Forces the switch to overwrite the configuration file without confirmation.