Configure Layer 2 Multi-area SPB I-SID Redistribution

Note

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure Multi-area SPB layer 2 redistribution.

Procedure

  1. In the navigation pane, expand the Configuration > IS-IS folders.
  2. Select MultiArea.
  3. Select the L2 ISID Redist tab.
  4. Select Insert.
  5. Configure the layer 2 I-SID redistribution parameters.
  6. Select Insert.

L2 Redistribute Field Descriptions

Use the data in the following table to use the L2 Redistribute tab.

Name Description

Type

Specifies the layer 2 Redistribution type.

Permit

Configures the Multi-area SPB layer 2 I-SID redistribution policy as permit or deny.

ExceptListName

Configures the name of layer 2 I-SID list. The system does not apply the Multi-area SPB layer 2 I-SID redistribution policy to I-SID values or the range of I-SID values in the layer 2 I-SID list.