Configuring the MLD query maximum response time

About this task

Use this procedure to configure the query maximum response time for mld interface.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the query maximum response time for mld interface:

    ipv6 mld query-max-response-time <0–60>

  3. Set the query maximum response time to its default value:

    default ipv6 mld query-max-response-time

Variable Definitions

The following table describes the variables for the ipv6 mld query-max-response-time command.

Variable Value

<0–60>

Indicates the query maximum response interval time in seconds.