Enable Remote IS-IS Router Configuration Globally

Note

Note

This procedure only applies to the VSP 7400 Series.

Before you begin

  • Configure manual-area in both home and remote area.

  • Configure the Shortest Path Bridging MAC (SPBM) instance and backbone VLANs (B-VLAN) manually.

  • Configure the nickname in both home and remote area manually.

About this task

Perform this procedure to enable remote IS-IS router configuration on the switch, globally.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable IS-IS router remote configuration:

    router isis remote [enable]

Example

Enabling IS-IS router remote configuration globally:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis remote enable

What to do next

To verify the configuration, see Display IS-IS Remote Area Configuration.

Variable Definitions

The following table defines parameters for the router isis remote command.

Variable Value
enable

Enables router IS-IS remote configuration globally on the switch.
9037147-00 Rev AB