The following sections provide procedural information you can use to configure Fabric Extend (FE) using Enterprise Device Manager (EDM).
Complete the configurations in the below table to configure Fabric Extend.
|
Step |
Procedure |
Description |
|---|---|---|
|
1 |
Configure the tunnel source address on the Globals tab. |
|
|
2 |
Configure the IS-IS logical interface for the Fabric Extend tunnel. |
|
|
3 |
Configure Fabric Extend on the switch at the other end of the tunnel |
Use the Fabric Extend procedures that apply to that switch model. |
For information about how to configure an IPsec NAT-T Responder, see IPsec configuration using EDM.