Configure Remote SPBM on an Interface

About this task

Perform this procedure to configure remote Shortest Path Bridging MAC (SPBM) on an interface.

Procedure

  1. In the navigation pane, expand the Configuration > Fabric folders.
  2. Select IS-IS Remote.
  3. Select the Interfaces tab.
  4. Select the SPBM button.
  5. Select Insert
  6. Configure the interfaces SPBM parameters.
  7. Select Insert.

SPBM Field Descriptions

Use data in the following table to use the Interfaces SPBM tab.

Name

Description

Index

Specifies an Index value for the remote SPBM interface.

SpbmId

Specifies the remote SPBM ID.

State

Specifies whether the remote SPBM interface is enabled or disabled.

Type

Configures the remote SPBM instance interface-type on the IS-IS interface on the specific port or MLT, the values are point-to-point (ptpt) or broadcast (bcast). The system supports the ptpt interface type only.

L1Metric

Configures the remote SPBM instance l1-metric on the IS-IS interface on the specific port or MLT. The default value is 10.

Origin

Specifies the source of the remote SPBM instance configuration.

  • config - configure manually through CLI or EDM.
  • dynamic - configure dynamically through Auto-sense.