Adding ports to an MLT LAG

Perform this procedure to add ports to an MLT LAG.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Add ports to an MLT LAG:

mlt <1-512> member {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Add port 1/24 to MLT 40:

Switch:1(config)#mlt 40 member 1/24

Use the data in the following table to use the mlt command.


Variable	Value
enable	Creates and enables a new MLT.
encapsulation dot1q	Enables trunking on the MLT.
member `{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}`	Adds ports to the MLT. Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
`<1-512>`	Specifies the MLT ID.
name `WORD<0-20>`	Configures the name for the MLT.
private-vlan `{isolated\|promiscuous\|trunk}`	Specifies a private VLAN type for the MLT.
vlan `<1-4059>`	Specifies a VLAN ID to add to the MLT.