View Multihost Status Information

Use the following procedure to display multiple host status for a port.

Procedure

  1. In the navigation pane, expand Configuration > Security > Data Path.
  2. Select 802.1X – EAPOL.
  3. Select the MultiHost Status tab.

MultiHost Status Field Descriptions

The following table describes values on the MultiHost Status tab.

Name

Description

PortNumber

Indicates the port number associated with this port.

ClientMACAddr

Indicates the MAC address of the client.

PaeState

Indicates the current state of the authenticator PAE state machine.

VlanId

Indicates the VLAN assigned to the client.

Priority

Specifies the priority associated with this client MAC. This priority could be the Radius assigned priority or the port QOS level.

SwUniBindings

Note: Exception: Not supported on VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Indicates the Extensible Authentication Protocol (EAP) VLAN:ISID bindings that the switch represents as an hexadecimal value.

IsidSource

Note: Exception: Not supported on VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Indicates the origin of I-SID value:

  • radius - received from the RADIUS server.
  • autoconfig - calculated using the auto-isid-offset command, that the user configures on the switch.
  • config - configured statically.
  • notAvaliable - does not use EAP with FlexUNI, hence there is no I-SID to use.

AclId

Note: Exception: Not supported on VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Indicates the dynamic Access Control List (ACL) on the specific port.
AceIdList
Note: Exception: Not supported on VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Indicates the list of dynamic Access Control Entries (ACE) on the specific port.

DynamicSettings

Displays the Dynamic settings received from the Remote Authentication Dial-In User Service (RADIUS) server.

MhsaDynamic

Specifies whether or not the switch receives the MHSA VSA settings from RADIUS.

9037602-00 Rev AB