Configure Remote SPBM Parameters

About this task

Perform this procedure to configure remote SPBM global parameters. SPBM uses the remote Intermediate-System-to-Intermediate-System (IS-IS) link state routing protocol to provide a loop free Ethernet topology that creates a shortest path topology from every node to every other node in the network based on node MAC addresses.

Procedure

  1. In the navigation pane, expand the Configuration > Fabric folders.
  2. Select SPBM Remote.
  3. Select the SPBM tab.
  4. Select Insert to create a remote SPBM instance.
  5. Configure the remote SPBM parameters.
  6. Select Insert.

SPBM Field Descriptions

Use data in the following table to use the SPBM tab.

Name

Description

Id

Specifies the remote SPBM instance ID.

NodeNickName

Specifies a nickname for the remote SPBM instance globally. The value is 2.5 bytes in the format <x.xx.xx>.

PrimaryVlan

Specifies the primary SPBM B-VLANs to add to the remote SPBM instance.

Vlans

Specifies the SPBM B-VLANs to add to the remote SPBM instance.

LsdbTrap

Enables or disables a trap when the SPBM LSDB changes. The default is disable.

IpShortcut

Enables or disables SPBM IP shortcut state. The default is disable.

SmltSplitBEB

Specifies whether the switch is the primary or secondary vIST peer. The default is primary.

SmltVirtualBmac

Specifies a virtual MAC address that can be used by both peers.

SmltPeerSysId

Specifies the system ID of the SPBM SMLT for this remote SPBM instance.

Mcast

Specifies if IP multicast over remote SPBM is enabled. The default is disabled.

McastFwdCacheTimeout

Specifies the global forward cache timeout in seconds. The default is 210 seconds.

Ipv6Shortcut

Enables or disables SPBM IPv6 shortcut state. The default is disable.

McastSpbPimGwControllerEnable

Enables or disables ISIS PLSB Multicast SPB PIM Gateway controller. Disabled by default.

McastSpbPimGwGatewayEnable

Enables or disables ISIS PLSB Multicast SPB PIM Gateway. Disabled by default.

StpMultiHoming

Enables or disables MSTP-Fabric Connect Multi Homing.

The default is disabled (false).

BVlanOrigin

Specifies the origin of the B-VLAN. The values are:

  • config - manual configuration using CLI or SNMP.
  • dynamic - through Auto-sense or Zero Touch Fabric Configuration.

The default is dynamic.