Assigning MEP/MIP Levels to SPBM B-VLANs Globally

Note

If you enable the cfm spbm enable command, you cannot assign a MEP/MIP level to an individual SPBM B-VLAN or configure CFM MD maintenance levels individually.

About this task

Enables the global CFM MEP and MIPs for all SPBM B-VLANs.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Enable simplified CFM configuration for SPBM VLANs:

cfm spbm enable
Enter the CFM SPBM level:

cfm spbm level <0–7>
Enter the CFM SPBM MEPID level:

cfm spbm mepid <1–8191>

Example

Switch:1(config)# cfm spbm level 7
Switch:1(config)# cfm spbm mepid 12
Switch:1(config)# cfm spbm enable

Variable Definitions

The following table defines parameters for the simplified CFM commands.


Variable	Value
spbm level `<0–7>`	Configures the maintenance level for every CFM SPBM MEP and MIP level on all SPBM B-VLANs. The default is 4.
mepid `<1–8191>`	Assigns a global MEP ID for all CFM SPBM MEPs. The default is 1.
no cfm spbm enable	Disables global configuration of CFM SPBM MEP and MIP levels on all SPBM B-VLANs.
default cfm spbm level	Returns maintenance level to default for all CFM SPBM MEP and MIP level on all SPBM B-VLANs.
default cfm spbm mepid	Returns MEP ID for all CFM SPBM MEPs to default.
show cfm spbm	Displays the global CFM MEP configuration for SPBM B-VLANs.