Configuring the SPB-PIM Gateway VLAN optional parameters

Configure the SPB-PIM Gateway interface parameters on a VLAN.

Procedure

  1. Enter VLAN Interface Configuration mode:

    enable

    configure terminal

    interface vlan <1–4059>

  2. Configure the SPB-PIM Gateway VLAN HELLO interval:

    ip spb-pim-gw hello-interval <0-18724>

  3. Configure the SPB-PIM Gateway VLAN JOIN PRUNE interval:

    ip spb-pim-gw ip join-prune-interval <1-18724>

Variable definitions

The following table defines parameters for the ip spb-pim-gw command.

Variable

Value

hello-interval<0-18724>

Specifies the HELLO interval in seconds. The default value is 30 seconds.

join-prune-interval<1-18724>

Specifies the JOIN PRUNE interval in seconds. The default value is 60 seconds.