Display the VTEP Next Hop

Note

Note

Exception: only supported on VSP 7200 Series, VSP 7400 Series, VSP 8200 Series, and VSP 8400 Series.

Use the following procedure to display information about the remote VTEP.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select VTEP.
  3. Select the Next Hop tab.

Next Hop field descriptions

Use the data in the following table to use the Next Hop tab.

Name

Description

VtepId

Specifies an index value in the range from 1 to 500 that uniquely identifies this remote VTEP.

Ip

Specifies an IP address that uniquely identifies this remote VTEP tunnel.

IfIndex

Specifies the interface index of the next hop to reach the remote VTEP.

Vid

Specifies the VLAN ID of the next hop to reach remote VTEP.