Configure EAP auto-isid-offset

Note

Note

This procedure does not apply to VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Before you begin

  • Enable EAP globally or on the port.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Configure an I-SID offset value:

    eapol auto-isid-offset <0-15995903>

  3. Enable EAP globally:

    eapol enable

  4. Confirm that your configuration is correct:

    show eapol system

Examples

Configure an I-SID offset value and enable I-SID offset globally on the switch:

Switch:1> enable
Switch:1#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#eapol auto-isid-offset 1000 
Switch:1(config)#eapol enable

View the current device configuration:

Switch:1>show eapol system
================================================================================
                                  Eapol System
================================================================================
                     eap : disabled
           Eapol Version : 3
         non-eap-pwd-fmt : mac-addr
     non-eap-pwd-fmt key : ******
 non-eap-pwd-fmt padding : disabled
 auto-isid-offset status : disabled
 auto-isid-offset value  : 1000

Variable Definitions

The following table defines parameters for the eapol auto-isid-offset command.

Variable

Value

<0-15995903>

Specifies the auto I-SID offset value.

The default is 15995903.

enable

Enables auto I-SID offset.

The default is disabled.