Viewing Ingress Port-rate Limit Statistics

Use this procedure to view the ingress port-rate limit statistics. The system displays the statistics of the dropped packets and bytes.

Note

This procedure is not supported on VSP 4450 Series and VSP 8600 Series.

Procedure

Enter Privileged EXEC mode:

enable
View the ingress port-rate limit statistics:

show interfaces gigabitethernet statistics rate—limiting [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Example

Switch:1# show interfaces gigabitethernet statistics rate-limiting 1/1

================================================================================
                   QOS Interface Ingress Rate-Limiting Stats
================================================================================
PORT     DROPPING          DROPPING          DROPPING          DROPPING
         PKTS RATE         BYTES RATE        PKTS              BYTES
--------------------------------------------------------------------------------
1/1		 9224						9260507           		1430758           		1436481032

Variable Definitions

Use the data in the following table to use the show interfaces gigabitethernet statistics rate-limiting command.


Variable	Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]}	Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.