Configure OSPFv3 on the CLIP Interface for a VRF Instance

About this task

Perform this task to configure an Open Shortest Path First Version 3 (OSPFv3) instance for a specific circuitless IP address on the Virtual Router Forwarding (VRF) instance.

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Create a VRF instance and specify a VRF name:

   ip vrf WORD<1-16>

3. Enter VRF Router Configuration mode:

   router vrf WORD<1-16>

4. Create an OSPFv3 instance on the specific VRF instance:

   ipv6 ospf

5. Enable OSPFv3 on the specific VRF instance:

   ipv6 ospf enable

6. Enter Loopback Interface Configuration mode:

   interface Loopback <1-256>

7. Create the IPv6 loopback interface address for the specific VRF instance:

   ipv6 interface address WORD<0-255> vrf WORD<1-16>

8. Create the OSPFv3 instance:

   ipv6 ospf [<1-256>] area {A.B.C.D}

9. Enable the OSPFv3 instance:

   ipv6 ospf [<1-256>] enable

Example

Configuring the OSPFv3 instance on the loopback interface on the VRF test:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#ip vrf test
Switch:1(config)#router vrf test
Switch:1(config-vrf)#ipv6 ospf
Switch:1(router-vrf)#ipv6 ospf enable
Switch:1(router-vrf)#interface Loopback 10
Switch:1(config-if)#ipv6 interface address 2001::10:10:0:1/128 vrf test
Switch:1(config-if)#ipv6 ospf 10 area 192.2.0.1
Switch:1(config-if)#ipv6 ospf 10 enable