Configure an ACE LAN Traffic Type

Perform this procedure to filter for specific LAN traffic packets.

Before you begin

  • The ACL exists.

  • The ACE exists.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > Security > Data Path.
  2. Select Advanced Filters (ACE/ACLs).
  3. Select the ACL tab.
  4. Select the appropriate ACL.
  5. Select ACE.
  6. Select the appropriate ACE.
  7. Select Eth.
  8. Select the Ethernet Type tab.
  9. Select Insert.
  10. Specify the operation type.
  11. In the TypeList box, type the Ethernet types.
  12. Select Insert.

Ethernet Type field descriptions

Use the data in the following table to use the Ethernet Type tab.

Name

Description

AclId

Specifies the ACL ID.

AceId

Specifies the ACE ID.

TypeOper

The eq parameter specifies an operator for a field match condition: equal to.

TypeList

Specifies the Ethernet type. Entries include: 0 to 0xffff or ip, arp, ipx802.3, ipx802.2, ipxSnap, ipxEthernet2, appleTalk, appleTalk-ARP, sna802.2, snaEthernet2, netBios, xns, vines, ipv6, rarp, PPPoE-discovery, and PPPoE-session.

Note:

Ethernet ACE filter configured with Ethernet Type ipx802.3 does not match the packet with format destination MAC address, source MAC address, length, 0xFFFF, payload and FCS.

Ethernet ACE filter configured with Ethernet Type ipx802.2 does not match the packet with format destination MAC address, source MAC address, length, 0xE0E0, payload and FCS.

9037602-00 Rev AB