Configure Remote IS-IS Hello Interval on a Port

About this task

Perform this procedure to configure the remote hello interval to change how often hello packets are sent out from an interface level.

1. Enter GigabitEthernet Interface Configuration mode:

   enable

   configure terminal

   interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

   

   Note

   If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

2. Configure the remote hello interval:

   isis remote l1-hello-interval <1-600>

Example

Configuring the remote hello interval on port 1/3:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/3
Switch:1(config-if)#isis remote l1-hello-interval 1