View Ingress Policer Statistics

Use this procedure to view the ingress policer statistics. The system displays individual policer statistics for specific ports to manage network performance.

Note

This procedure only applies to VSP 8600 Series, VSP 4450 Series and XA1400 Series.

Procedure

Enter Privileged EXEC mode:

enable
View the policer statistics:

show interfaces gigabitethernet statistics policer {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Example

Switch:1# show interfaces gigabitethernet statistics policer 1/3

=========================================================================================
                                  QoS Ingress Port Policer Stats
==================================================================================================
PORT     TOTAL                 TOTAL                 YELLOW                RED
NUM      PKTS                  BYTES                 BYTES                 BYTES
--------------------------------------------------------------------------------------------------
1/3      420                   31628                 0                     0

Variable Definitions

Use the data in the following table to use the show interfaces gigabitethernet statistics policer command.


Variable	Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]}	Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.