l2ports Commands

This section describes commands to enable and disable ports on the Wireless Appliance. These commands are located in the l2ports context of the CLI. L2 port configuration is performed within a named topology context. See l2 for L2 port configuration information.

All CLI commands cache changes. For this reason, sometimes when you make a change in a particular context, the change may not be visible immediately. If this happens, you must exit and re-enter the context in order to ensure that the database is synchronized with the latest change.

The following commands are available in the l2ports context:

• esaN
• jumbo-frames
• portN
• show
• <named-LAG-port> — See for commands in the l2ports:<named-LAG-port> context.