secure-tunnel

Use the secure-tunnel command to enable or disable a secure tunnel on this site. The secure-tunnel command is accessible from the ap:<serial> and all ap:defaults contexts of the CLI.

secure-tunnel disable | control | data | debug

Parameters

disable Disables a secure tunnel between this AP and the controller.
control Enables a secure tunnel by encrypting control traffic between the AP and the controller.
data Enables a secure tunnel by encrypting control and data traffic between the AP and the controller.
debug Enables tunnel in debug mode, which preserves keys without encryption.

Usage

If enabling a secure tunnel, specify the type of traffic this tunnel will encrypt and carry: control traffic, or control and data traffic. Secure tunneling can also be used for debug mode (keys are preserved without encryption).
Note

Note

For some AP models, the data option is not available.

Example

The following example enables a secure tunnel that encrypts control and data traffic on AP37xxs:

EWC.extremenetworks.com:ap:defaults:ap37xx# secure-tunnel data