name

Use the name command in the vnsmode:<named-VNS> context to change the name of the current VNS.

After you run the name command, run the apply command to implement the changes.

name VNS-name

Parameters

VNS-name Specifies the new name for the current VNS.

Example

The following example changes the name of VNS1 to VNS2, then uses the show command to display information for the current VNS, including its name:

EWC.extremenetworks.com:vnsmode:VNS1# name VNS2
EWC.extremenetworks.com:vnsmode:VNS1# apply
EWC.extremenetworks.com:vnsmode:VNS1# show
WLANS service: test
Non-authenticated: p4
Authenticated: same as non-authenticated
Restrict available role set: disable
Enable status: enable
Synchronize: disable
Name: VNS2