domain

Use the domain command to configure a domain name. The domain command is available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and routed topologies. This command is visible only when mode is set to local. See mode.

domain domain name | none

Parameters

domain name Specifies the domain name or an IPv4 address.
none Clears the domain name.

Example

The following example sets the domain name as my-domain:

EWC.extremenetworks.com:topology:test:l3:dhcp# mode local
EWC.extremenetworks.com:topology:test:l3:dhcp# domain my-domain