update_period

Use the update_period command to set the DCS update period, during which the Wireless AP averages the DCS noise threshold and DCS channel occupancy threshold measurements. If either one of these thresholds is exceeded, the Wireless AP triggers ACS. The update_period command is accessible from all radio dcs contexts of the CLI.

update_period period

Parameters

period Specifies the time period, measured in minutes, during which the Wireless AP averages the DCS noise threshold and DCS channel occupancy threshold measurements. If either one of these thresholds is exceeded, then the Wireless AP triggers ACS.

Range is 1 to 15 minutes, or 0 to disable.

Example

The following example sets the DCS update period to 12 minutes:

EWC.extremenetworks.com:ap:defaults:ap37xx:radio1:dcs# update_period 12

The following example disables the DCS update period:

EWC.extremenetworks.com:ap:defaults:ap37xx:radio1:dcs# update_period 0